49Y4234 IBM Emulex Dual-Port 10GBE Virtual Fabric Adapter

General Information

49Y4234 IBM Emulex Dual-Port 10GBE Virtual Fabric Adapter

Technical Specs

• Connection to either 1 Gb or 10 Gb data center infrastructure (1 Gb and 10 Gb auto-negotiation)
• PCI Express 2.0 x8 host interface
• IBM BladeCenter CFFh form factor; can be combined with a CIOv expansion card in the same server
• Operates either as an 8-port Virtual Fabric Adapter or as a 2-port 1/10 Gb Ethernet adapter
  • Virtual port bandwidth allocation in 100 Mbps increments
  • Supports up to eight virtual ports
• Wake On LAN support
• Full-duplex (FDX) capability
• Bus-mastering support
• Direct memory access (DMA) support
• Preboot Execution Environment (PXE) support
• IPv4/IPv6 TCP, UDP checksum offload
  • Large send offload (LSO)
  • Large receive offload
  • Receive side scaling (RSS)
  • IPV4 TCP Chimney Offload
• VLAN insertion and extraction
• Jumbo frames up to 9000 bytes
• Load balancing and failover support including adapter fault tolerance (AFT), switch fault tolerance (SFT), adaptive load balancing (ALB), teaming support, and IEEE 802.3ad
• Enhanced Ethernet (draft)
  • Enhanced Transmission Selection (ETS) (P802.1Qaz)
  • Priority-based Flow Control (PFC) (P802.1Qbb)
  • Data Center Bridging Capabilities eXchange Protocol, CIN-DCBX and CEE-DCBX (P802.1Qaz)
• iSCSI hardware initiator support with Advanced card or Advanced Upgrade
• FCoE support planned with Advanced card or Advanced Upgrade
• Configurable from the BNT Virtual Fabric 10Gb Switch Module